Replace the Base Module Chassis

Replacing the Base Module is very similar to installing a new Base Module.

• Install the Base Module into the Rack
• Install the Base Module CRUs and Expansion Modules
• Reinstall Magazines and Dress the Cables

Install the Base Module into the Rack

The Base Module mounts into a standard 19-in rack.

1. Grasp the Base Module chassis by the sides and remove it from the shipping carton.
2. If there are no Expansion Modules for this library, install the floor in the Base Module.

   See Install the Floor in the Bottom Expansion Module.

3. Mount the Base Module.

Install the Base Module CRUs and Expansion Modules

Reinstall the function components removed from the defective Base Module and install any Expansion Module.

1. Reinstall the Base Module components.
   • Replace the Robot Module
   • Replace the Drive Tray
   • Install the Drive Slot Cover
   • Replace the Power Supply
   • Install a Power Supply Slot Cover
   • Replace the Front Control Panel
2. Reinstall the Expansion Modules. See Replace the Expansion FRU Chassis. Make sure to install the floor in the bottom module.
3. Re-cable the Expansion Modules. Connect the specific Base Module port to the controller card port of the associated Expansion Module. See Cable the Expansion Modules for details.

Reinstall Magazines and Dress the Cables

Reinstall the cartridge magazines into all modules and dress any cabling.

1. Install cartridge magazines in all modules.

   See Replace the Cartridge Magazines.

2. Align and dress the cables. Secure the cables in the hook and loop straps, if applicable.

   Figure 10-8 Cable Attachment

   

   Illustration Legend:

   • 1 - Tape Drive With Fibre Channel Cable
   • 2 - Expansion Module Cable
   • 3 - Ethernet Cable
   • 4 - Power Supply Cord
   • 5 - Tape Drive With SAS Cable
3. Connect the power cord to each installed power supply.
4. Follow the power on procedures.

   See Validate the Component Installation.