arp

- address resolution display and control

Synopsis

arp hostname

arp -a [-n]

arp -d hostname

arp -f filename

arp -s hostname ether_address [temp] [pub] [trail] 
     [permanent]

Description

The arp program displays and modifies the Internet-to-MAC address translation tables used by the address resolution protocol (see arp(7P)).

With no flags, the program displays the current ARP entry for hostname. The host may be specified by name or by number, using Internet dot notation.

Options that modify the ARP translation tables (-d, -f, and -s) can be used only when the invoked command is granted the sys_net_config privilege. See privileges(5).

Options

-a

Display all of the current ARP entries. The definition for the flags in the table are:

d

Unverified; this is a local IP address that is currently undergoing Duplicate Address Detection. ARP will not respond to requests for this address until Duplicate Address Detection completes.

o

Old; this entry is aging away. If IP requests it again, a new ARP query will be generated. This state is used for detecting peer address changes.

y

Delayed; periodic address defense and conflict detection was unable to send a packet due to internal network use limits for non-traffic-related messages (100 packets per hour per interface). This occurs only on interfaces with very large numbers of aliases.

A

Authority; this machine is authoritative for this IP address. ARP will not accept updates from other machines for this entry.

L

Local; this is a local IP address configured on one of the machine's logical interfaces. ARP will defend this address if another node attempts to claim it.

M

Mapping; only used for the multicast entry for 224.0.0.0

P

Publish; includes IP address for the machine and the addresses that have explicitly been added by the -s option. ARP will respond to ARP requests for this address.

S

Static; entry cannot be changed by learned information. This indicates that the permanent flag was used when creating the entry.

U

Unresolved; waiting for ARP response.

You can use the -n option with the -a option to disable the automatic numeric IP address-to-name translation. Use arp -an or arp -na to display numeric IP addresses. The arp -a option is equivalent to:

# netstat -p -f inet

...and -an and -na are equivalent to:

# netstat -pn -f inet

-d

Delete an entry for the host called hostname.

-f

Read the file named filename and set multiple entries in the ARP tables. Entries in the file should be of the form:

hostname MACaddress [temp] [pub] [trail] [permanent]

See the -s option for argument definitions.

-s

Create an ARP entry for the host called hostname with the MAC address MACaddress. For example, an Ethernet address is given as six hexadecimal bytes separated by colons. The entry will not be subject to deletion by aging unless the word temp is specified in the command. If the word pub is specified, the entry will be published, which means that this system will respond to ARP requests for hostname even though the hostname is not its own. The word permanent indicates that the system will not accept MAC address changes for hostname from the network.

Solaris does not implement trailer encapsulation, and the word trail is accepted on entries for compatibility only.

arp -s can be used for a limited form of proxy ARP when a host on one of the directly attached networks is not physically present on a subnet. Another machine can then be configured to respond to ARP requests using arp -s. This is useful in certain SLIP configurations.

Attributes

See attributes(5) for descriptions of the following attributes:

See Also

ifconfig(1M), netstat(1M), attributes(5), privileges(5), arp(7P)