Go to main content

Sun Fire X4800 Server Product Notes

Exit Print View

» ...Documentation Home » Sun Fire X4800 Documentation Library » Sun Fire X4800 Server Product Notes » Oracle ILOM Enhancements and Issues » Use the Locate Button to Prove Physical ...

Updated: September 2018

Sun Fire X4800 Server Product Notes

Document Information

Using This Documentation

Important Operating Notes

Supported Software and Firmware

Oracle x86 Products Accessibility

Hardware Issues

Oracle Solaris 10 Operating System Issues

Oracle VM Issues

Windows Operating System Issues

Oracle ILOM Enhancements and Issues

Updated Licensing Information for Oracle ILOM

Use Oracle ILOM 4.0 Documentation After Updating to Firmware Version 2.0.0 or Newer

File Transfer Using URI Fails if Target Password Contains Certain Special Characters (25917655)

Oracle ILOM SNMP v3 Traps Are Not Delivered After SNMP Engine ID Change (23634048)

Third-Party Web Scan and Test Tools Cause Sluggish Oracle ILOM Performance (23564626)

Oracle ILOM Enhancement Allows IPv4 Only, IPv6 Only, or Dual Stack

New Procedures for Updating CPLD (CR 7043418)

Update Oracle ILOM and BIOS Firmware Before Updating Other Device Firmware (CR 6537282)

Use the Locate Button to Prove Physical Presence (CR 6881237)

NEM Expander Firmware Update Procedure (CR 6979140)

Network Management Port 1 Does Not Work (CR 6935471 and 6854694)

start /SYS and stop /SYS Commands Cause Power Button Pressed Event In Log (CR 6906176)

Event Log Messages Might Be Out of Sequence and Duplicated (CR 6915976)

Incorrect Error Message in Event Log After Restore When Serial Console or JavaRconsole Session Are Open (CR 6917474)

Allocated Power Figures Are Incomplete (CR 6931837)

(Fixed in SW 1.1) LDAP Account Cannot Be Used to Start Console (CR 6969473)

(Fixed in SW 1.1) Power Cycling the Host Using the Web Interface Generates an Error (CR 6909374)

(Fixed in SW 1.1) DIMM Mismatch Fault Not Cleared After DIMM Replacement and Host Power Cycle (CR 6972285)

(Fixed in SW 1.0.1) Console Redirect from CLI Fails (CR 6939479)

(Fixed in SW 1.0.1) Oracle ILOM Only Allows One Console Session (CR 6895423)

(Fixed in SW 1.0.1) Faults Disappear After SP Reset (CR 6928998)

(Fixed in SW 1.0.1) Clearing a Power Supply Unit (PSU) Fault Erases Other Fault Information (CR 6933348 and CR 6939306)

(Fixed in SW 1.0.1) pciflash Is Not Available (CR 6867060 and CR 6904922)

Oracle Hardware Installation Assistant Issues

Language:

Use the Locate Button to Prove Physical Presence (CR 6881237)

Certain Oracle ILOM procedures require you to “prove physical presence”. To do this, press the Locate button located on the system front panel.

For details, see Front and Back Features and Components in Sun Fire X4800 Server Installation Guide.

Copyright © 2017, 2018, Oracle and/or its affiliates. All rights reserved.