Testing the Installation (Oracle Solaris)

This section describes how to confirm that the HBA is installed and functioning. The section contains the following topics:

• To Verify Proper Installation (Oracle Solaris)

• To Verify Attached Storage (Oracle Solaris)

To Verify Proper Installation (Oracle Solaris)

1. Use the cfgadm command to verify proper HBA installation:

   If the HBA is properly installed and connected, you will see output similar to the following:

   cfgadm
          Ap_Id               Type         Receptacle   Occupant     Condition
          c3                  fc           connected    configured   ok
          c4                  fc           connected    configured   ok
          pcie5               fibre/hp     connected    configured   ok

2. If an HBA adapter is shown as unconfigured or disconnected, use the cfgadm ‐c configure command to configure the adapter.

To Verify Attached Storage (Oracle Solaris)

1. Use the cfgadm -al command to verify attached storage:

   If the HBA is properly installed and storage is connected properly, you will see output similar to that shown below. In this example, one port of an HBA adapter is connected through a fabric switch to two ports of a disk array.

           Ap_Id                  Type         Receptacle   Occupant     Condition
           c3                     fc-fabric    connected    configured   unknown
           c3::200600a0b816005e   disk         connected    configured   unknown
           c3::200700a0b816005e   disk         connected    configured   unknown
           c4                     fc           connected    unconfigured unknown
           pcie5                  fibre/hp     connected    configured   ok

2. If an adapter is shown as unconfigured, use the cfgadm -c configure command to configure it.