Skip Navigation Links | |
Exit Print View | |
![]() |
Sun Ethernet Fabric Operating System VLAN Administration Guide |
Configuring Static VLAN Entries
Retrieve the Configuration Details for all of the VLANs on a Switch
Retrieve the Configuration Details of a particular VLAN on the Switch
Configure a Static Unicast Entry
Configure a Static Multicast Entry
Configure Dynamic VLAN Learning
Configure Dynamic Multicast Learning
Configure Restricted VLAN Registration
Configure Restricted Group Registration
Configuring Service Classes and Expedited Traffic
Map a Priority to Traffic Class
Configuring Static Unicast and Multicast Entries
Configure Static Unicast Entry in Topology 1
Configure Static Unicast Entry in Topology 2
Configure VLANs on the Nonroot Bridge
Configure Restricted VLAN Registration
You can configure the acceptable frame type for the port as one of the following:
All frames
Tagged frames
Untagged and priority tagged frames
In the following example, the frame type is set to tagged.
SEFOS# configure terminal SEFOS(config)# interface extreme-ethernet 0/2 SEFOS(config-if)# switchport acceptable-frame-type tagged SEFOS(config-if)# end SEFOS(config)# exit
SEFOS# show vlan port config port extreme-ethernet 0/2 Vlan Port configuration table ------------------------------- Port Ex0/2 Port Vlan ID : 1 Port Acceptable Frame Type : Admit Only Vlan Tagged Port Ingress Filtering : Disabled Port Mode : Hybrid Port Gvrp Status : Disabled Port Gmrp Status : Disabled Port Gvrp Failed Registrations : 0 Gvrp last pdu origin : 00:00:00:00:00:00 Port Restricted VLAN Registration : Disabled Port Restricted Group Registration : Disabled Mac Based Support : Disabled Subnet Based Support : Disabled Port-and-Protocol Based Support : Enabled Default Priority : 0 Tunnel Status : Disabled Dot1x Protocol Tunnel Status : Peer LACP Protocol Tunnel Status : Peer Spanning Tree Tunnel Status : Peer GVRP Protocol Tunnel Status : Peer GMRP Protocol Tunnel Status : Peer IGMP Protocol Tunnel Status : Peer Filtering Utility Criteria : Default Port Protected Status : Disabled -------------------------------------------------------
Note - When set to tagged, the device discards untagged and priority tagged frames received on the port. The device will process only the VLAN tagged frames.