StorageTek Tape Analytics Configuration Guide, Version 1.0.2 |
E28378-04 |
You use the following process to configure the libraries to send SNMP traps to STA. Perform the entire process for your library model, as per TABLE 1‑4.
After you complete this process, you will configure STA to receive SNMP traps from the library (Chapter 2, “Configuring SNMP in the STA Application”).
Note – Before performing the SNMP configuration steps, see “SNMP Configuration for STA” for important background information for these procedures.
Note – The SNMP configuration procedures describe the recommended v3 protocol configuration. See Appendix A, “Configuring SNMP v2c Mode” for information on configuring the v2c protocol.
Prepare service requests for Oracle support (if not done already). See “Pre-Installation Planning” in the STA Planning and Installation Guide. |
|||||
“Log In to the Library”. (See “Library User Interfaces” for important information about the available login methods.) |
|||||
“Enable ADI on the Library” (libraries with LTO drives only). |
|||||
Copyright © 2012, 2013 Oracle and/or its affiliates. All rights reserved. | Legal Notices |