Install a New Card

Language:

Before You Begin

To install a new Sun Flash Accelerator F80 PCIe Card:

Prepare the card for installation.
See Preparing the Card for Installation.
1. Gather the required tools.
  See Required Tools .
2. Unpack the shipping kit that includes the card.
  See Ship Kit Contents.
3. Remove the card from the antistatic bag using good good antistatic grounding procedures.
  See ESD Safety Measures.
4. Carefully inspect the card for damage.
  If you notice any damage, contact Oracle support , or your reseller support representative. Go to: https://support.oracle.com.

Prepare the server for service.
Refer to the servers service manual.
1. Remove the server from active operation.
2. Turn off the server.
  Power down the system.
3. Disconnect all power cords from the server power supplies.
  Refer to the servers service manual.
4. Remove the cover from the chassis.
Caution - Electric shock hazard. Disconnect the server from the main power and from any networks before installing the card to avoid electrical shock.

Identify a supported and available PCI Express slot in the server.
Refer to the Sun Flash Accelerator F80 PCIe Card Product Notes at http://www.oracle.com/goto/SunFlashF80/docs.
Note - Exceeding the maximum number of Sun Flash Accelerator F80 PCIe Cards or placing cards in unsupported slots results in host platform error report and shutdown.

Insert the card in the supported PCI Express slot.
1. Remove the blank bracket panel on the server chassis that aligns with the empty PCI Express slot.
  Save the bracket screw, if applicable.
2. Align the card to the PCI Express slot.
3. Press down gently, but firmly, to properly seat the card in the slot.
  The following figure shows how to insert the card in a PCI Express slot:
  Figure 3 Sun Flash Accelerator F80 PCIe Card Installation
  
  Figure Legend
  1Bracket screw
  2Press here
  3Press here
  432-bit slot (3.3 V only)
  5PCI express x8 slot
  664-bit slot (3.3 V only)
  7Motherboard
  
  Note - Your server chassis may contain a card riser or other configuration. Refer to the servers service manual for card installation instructions.

Secure the card bracket to the server chassis.
- Install the bracket screw, as required, to secure the card to the server chassis. or
- Engage the server retention mechanism to secure the card to the server chassis.

Return the server to service.
Refer to the servers service manual.
1. Replace the cover.
2. Reconnect the power cord and any network cables.
3. Power on the system.
The card hardware installation is complete.

If applicable, perform any required commands for your system to recognize the new card.
For the Oracle Solaris OS, enter the reboot command with the reconfiguration option. Refer to the servers administration guide.

Verify successful installation of the card through your systems OS.
Upon completed installation, the Sun Flash Accelerator F80 PCIe Card appears on your server. Refer to the servers administration guide.

Configure the system to maximize flash technology.
Refer to the Sun Flash Accelerator F80 PCIe Card Product Notes at http://www.oracle.com/goto/SunFlashF80/docs.
Refer to the servers administration guide.