The Network Settings tab is used to configure networking and service information for the management nodes. The following fields are available for configuration:
Management Node 1:
IP Address: Specify an IP address within your datacenter network that can be used to directly access this management node.
Hostname: Specify the host name for the first management node system.
Management Node 2:
IP Address: Specify an IP address within your datacenter network that can be used to directly access this management node.
Hostname: Specify the host name for the second management node system.
Management Node Cluster:
Management Network VLAN:
No VLAN: By default this radio button is set. The default configuration does not assume that your management network exists on a VLAN.
VLAN Enabled: If you have configured a VLAN on your switch for the management network, you should set this radio button and then specify the VLAN ID for the VLAN that the management network must use in the provided field.
Virtual IP: Specify the shared Virtual IP address that is used to always access the active management node. This IP address must be in the same subnet as the IP addresses that you have specified for each management node.
Domain Name: Specify the domain that each of the management node systems belong to.
Netmask: Specify the netmask for the network that the Virtual IP address and management node IP addresses belong to.
Default Gateway: Specify the default gateway for the network that the Virtual IP address and management node IP addresses belong to.
NTP: Specify the NTP server that the management nodes and other appliance components must use to synchronize their clocks to.
DNS: Specify at least one DNS server that the management nodes can use for domain name resolution.
Current PCA Password: You must enter the current Oracle PCA password to make changes to any of these settings.
Clicking the button at the bottom of the
page saves the settings that are currently displayed on the page
and updates the configuration on each of the management nodes. The
ovca services are restarted in the process, so
you are required to log back in to the Dashboard afterwards.
