Install the Storage Server Into the
Slide-Rail Assemblies
Use this procedure to install the storage server chassis,
with mounting brackets, into the slide-rail assemblies that are
mounted to the rack.
| Caution -
Personal Injury or Equipment Damage: This
procedure requires a minimum of two people because of the weight of the storage
server.
|
| Caution -
To prevent the rack from tipping during equipment installation, extend your rack's
anti-tilt bar.
|
- Push
the slide-rails into the slide-rail assemblies in the rack as far
as possible.
- Position the storage server so that the
rear ends of the mounting brackets are aligned with the slide-rail
assemblies that are mounted in the rack.
-
Insert the mounting brackets into the slide-rails, and then push the storage
server into the rack until the mounting brackets encounter the slide-rail stops
(approximately 12 inches, or 30 cm).
|
|
1
|
Inserting mounting bracket into slide-rail
|
2
|
Slide-rail release lever
|
|
-
Simultaneously pull down and hold the slide-rail release levers on each mounting
bracket while you push the storage server into the rack. Continue pushing the storage
server into the rack until the slide-rail locks (on the front of the mounting
brackets) engage the slide-rail assemblies.
You will hear an audible click.
| Caution -
Verify that the storage server is securely mounted in the rack and that the
slide-rail locks are engaged with the mounting brackets before you install the
optional cable management arm.
|