Attach Tool-less Slide-Rail Assemblies

Use this procedure to attach tool-less slide-rail assemblies to the rack.

1. Orient the slide-rail assembly so that the ball-bearing track is forward and locked in place.
   

   Figure Legend 1 Slide-rail 2 Ball-bearing track 3 Locking mechanism

2. Starting with either the left or right side of the rack, align the rear of the slide-rail assembly against the inside of the rear rack rail, and push until the assembly locks into place with an audible click.
   
3. Align the front of the slide-rail assembly against the outside of the front rack rail, and push until the assembly locks into place with an audible click.
4. Repeat the previous steps to attach the slide-rail assembly to the other side of the rack.

Related Information

• Install Mounting Brackets

• Mark the Rackmount Location

• Install the Controllers Into the Slide-Rail Assemblies