Installation Troubleshooting
If you experience problems while setting up your appliance, see the
troubleshooting information in the following table.
|
|
Controller powers on, but the monitor does not.
|
-
Is the Power button for the monitor turned on?
-
Is the monitor power cord connected to a wall
outlet?
-
Is the monitor power cord connected to the monitor?
-
Does the wall outlet have power? Test by plugging in
another device.
|
No video is displayed on the monitor screen.
|
-
Is the monitor cable attached to the video
connector?
-
Does the monitor work when connected to another
system?
-
If you have another monitor, does it work when connected
to the original system?
-
If, after POST and BIOS are complete, you no longer see
video output on your monitor and see only a flashing cursor,
check the configuration of the operating system to determine
if it is configured to redirect its output exclusively over
the serial line.
|
Controller does not power on when the front panel Power button is
pressed.
|
Keep notes on the following situations in case you need to call
Oracle Service Personnel:
-
Is the Power/OK LED illuminated on the front of the
system? (Ensure that the power cord is connected to the
system and to a grounded power receptacle.)
-
Does the wall outlet have power? Test by plugging in
another device.
-
Does the monitor sync within five minutes after power-on?
(The green LED on the monitor stops flashing and remains
illuminated.)
-
Check Oracle ILOM fault management settings to ensure that
there are no faulty components or incorrect power management
settings that might be preventing the system from powering
on.
|
|