Table of Contents

• Title and Copyright Information
• My Oracle Support (MOS)
• What's New in This Guide
• 1 Introduction
  • Overview
  • Scope and Audience
  • Documentation Admonishments
  • Manual Organization
  • Related Publications
  • Regulatory Compliance and Certification
  • Environmental Requirements
  • Hardware Repair and Return
    • Repair and Return Shipping Instructions
    • Returning a Crate
• 2 Safety Information
  • General
  • Frames
  • Power
  • Electrostatic Discharge
  • Components
• 3 General Installation Information
  • Hardware Operational Testing
  • Components Overview
  • Card Installation and Replacement
  • Labeling
    • Cable Labeling
    • Fuse and Alarm Panel Labeling
      • Label Kit for FAP (P/N 870-2804-001)
      • Label Kit for FAP (P/N 870-1606-xx/870-2320-xx)
  • EAGLE Post-Installation Inspection
• 4 Frames and Shelves
  • Unpacking
  • Floor Preparation
    • Recommended Tools
    • Raised Floor
      • Recommended Tools
      • Drill Cable Holes
      • Heavy Duty Frame Anchoring
      • Raised Floor Earthquake Bracing
    • Concrete Floor
    • Recommended Tools
  • Anchoring to Overhead Rack of Heavy Duty Frame
  • Removing Frame Panels
  • Installing Unit Separation Brackets
  • Rear Covers
  • Shelves
  • Labeling
    • End Aisle Labeling
    • Frame Labeling
    • Shelf Labeling
• 5 Fuses and Alarm Panel
  • Fuse and Alarm Panels
    • Fuses
    • Fuse and Alarm Panel (P/N 870-2804-01)
      • Shorting Board
        • Maintenance Mode
        • Normal Mode
    • Fuse and Alarm Panel (P/N 870-1606-xx/870-2320-xx)
      • Jumper Board
        • Maintenance Mode
        • Operational Mode
    • Provision Rules for FAP Fuse Locations
  • Installing Power Cables
    • Recommended Tools
  • Frame Ground and Logic Ground Cabling Procedures
    • Recommended Tools
    • Ground Frame
    • Connect Ground Cable to Control Frame
    • Logic Ground Connections to the System Ground Bar
    • Logic Ground Cables
  • Fuse Verification
  • Verification of Fuse Alarm Function
  • FAP Alarm System Test
  • Fuse Assignments
  • Fuse and Card Locations
  • Card Locations in Control and Extension Shelves
• 6 Assemblies
  • Intra-system Cable Installation
    • Install IMT Cables
      • Rack Alarm and Row Alarm Cable Routing
    • Interface Cable Installation
      • Interface Cable Installation Order
        • Control Frame CF-00 Backplane
        • Extension Frame EF-00
        • Extension Frame EF-01
        • Extension Frame EF-02
        • Extension Frame EF-03
        • Extension Frame EF-04
      • Recommended Tools
    • LAN Ethernet Cable Installation for ACM
      • Customer Supplied Ethernet Cable Requirements
      • Recommended Tools
  • E5-ENET/E5-ENET-B and Fan Option, EDCM, E5-SM4G/E5-SM8G-B Cabling
  • User Upgrade Procedures
    • Upgrading to E5-MCPM-B Module (MCPM)
    • Measurement Collection and Polling Module (MCPM)
    • Removing a Card in an Existing EAGLE System
  • Fan Assembly Installation and Cabling
    • Installing Fan Assembly 890-0001-04
    • Installing Fan Cables
    • Powering Up the Fan Assembly
    • Installing Fan Assembly 890-1038-01 or 890-1038-02
    • Installing Fan Cables
    • Powering Up the Fan Assembly
    • Testing the Fan Assembly
  • Source Timing
    • HS Source and Composite Clock Cables on Backplane P/N 850‑0330‑06/07
    • HS Source and Composite Clock Cables on Backplane P/N 850‑0330‑03/04
  • A Clock and B Clock Cable Replacement
    • Procedure — Replacing A Frame Clock Cables
    • Procedure — Replacing B Frame Clock Cables
  • Termination of Alarm, Clock Supply, and Terminal Cables
    • Alarm Cable Termination
    • Terminate Clock Supply Cables
    • Terminal Cables
  • Holdover Clock Installation
    • Output Panel Connections
    • Holdover Clock Switch Settings
    • Clock Input DIP Switch Settings
    • Output Panel Connections
    • Holdover Clock Alarm Connections
      • BITS Clock Source Cables
    • Replacing Holdover Clock Rear Cover
    • Install Holdover Clock Fuses
  • Ohms Converter International Market
  • Hardware Acceptance
  • –48VDC Power Source
    • Verify -48VDC
• A LED Information
  • Introduction
  • CI, Clock Interface Card, Holdover Clock
  • E5-ATM-B Interface Module
  • E5-E1T1-B Interface Module
  • E5-ENET-B Interface Module
  • E5-MASP Card
  • E5-MCPM-B Module
  • E5-MDAL Card
  • E5-SM8G-B Module
  • HIPR2, High-Speed IMT Packet Router 2 Module
  • MIS, Maintenance Interface System, Holdover Clock
  • MCA, Matrix Controller Assembly Card, Holdover Clock
  • SLIC Module
  • ST3, Stratum-3 Clock Card, Holdover Clock
  • TOCA, Timing Output Composite Automatic, Holdover Clock
• B Backplane Connectors
  • Control Shelf Connectors
    • Control Shelf Backplane 04
    • Control Shelf Backplane 06/07
    • Overview of the Control Shelf Backplane Connectors
    • Power Connectors
      • Fuse and Alarm Panel 870-2320-01/03
        • Shelf Power
      • Rack Alarm (Alarm Interface)
      • Fan Power
    • Alarm Connectors
      • Local Maintenance Center Alarm Connector
      • Remote Maintenance Center Alarm Connector
      • Rack Alarm Connectors
      • Row Alarm Connector
      • External Alarm Connector
      • OAP Alarm Connector
    • System Clock Connectors
      • A Clock 0 through A Clock 5
      • B Clock 0 through B Clock 5
    • Shelf Clock Connectors (for Control Shelf Backplane -04 only)
      • Clock A In Connector
      • Clock A Out Connector
      • Clock B In Connector
      • Clock B Out Connector
    • BITS Clock Connectors
    • Serial Port Connectors
    • Interface Connectors
      • Control Shelf Modules
        • Control Shelf Backplane Pin-Outs, Top Connector
        • Control Shelf Backplane Pin-Outs, Bottom Connector
        • Control Shelf Backplane Pin-Out Symbols
      • Maintenance Disk and Alarm Connector
        • MDAL Pin-Outs, Top Connector
        • MDAL Pin-Outs, Bottom Connector
      • Terminal Disk Module
        • TDM Pin-Outs, Top Connectors
        • TDM Pin-Outs, Bottom Connector
    • Interprocessor Message Transport Connectors
    • General Purpose Relay Connectors
      • GP01
      • GP02
    • General Purpose Serial Interface Connectors
  • Extension Shelf
    • Extension Shelf Backplane 04
    • Power Connectors
    • System Clock Connectors
      • Clock A In Connector J5
      • Clock A Out Connector J6
      • Clock B In Extension Shelf Connector J41
      • Clock B Out Extension Shelf Connector J42
    • Interface Connectors
      • Extension Shelf Modules
        • Extension Shelf Backplane Pin-Outs, Top Connector
        • Extension Shelf Backplane Pin-Outs, Bottom Connector
        • Extension Shelf Backplane Pin-Out Symbols
    • Interprocessor Message Transport Connectors
• C Cables and Adapters
  • Labeling Cables
    • Procedure - Cable Labeling
  • Cables and Adapters
    • Cable and Adapter Use
    • Alarm Cable (Holdover Clock)
    • Alarm NETRA Server Cable (P/N 830-0900-xx)
    • B-Clock Cable
    • BNC- to-BNC Cable Assembly (P/N 830-0624-xx)
    • BNC/Open End Cable
    • Breaker-to-Terminal Strip Power Cable
    • CD ROM Cable
    • Converter
    • Crossover (CAT-5) Cable
    • Crossover DCM Patch Panel Cable
    • DCM, 100-BASE TX Interface
    • Drive Power Cable
    • DS1 Cable
    • E1 Cable
    • E1 Patch Cable
    • E5-ATM Adapter
    • E5-ENET ADAPTER (DB26 Male-to-Dual RJ45)
    • E5-ENET ADAPTER (DB26 Male-to-DB26 Female)
    • E5-ENET FAST COPY ADAPTER, LOWER
    • E5-ENET FAST COPY ADAPTER, UPPER
    • ENET Adapter 15-Pin to 26-Pin (P/N 830-0425-01)
    • External Alarm Cable (Custom)
    • Fan Power and Alarm Cable
    • Fifty Position Hard Drive I/O Cable
    • Filter Rack Alarm Cable
    • Force Transition Card
    • Hazard Ground Cable
    • High Speed Source Timing Adapter
    • IMT Cable High Speed
    • Interface Cable
    • Local Maintenance Center Cable
    • Loop Back Cable Adapter
    • Source Clock Cable (BITS/High-speed)
    • Source High Speed Clock Adapter
    • MMI Port Cable
    • Modem/Terminal Cable
    • Network Cable
    • Null Modem Cable
    • Null-Modem for Terminal Cable
    • Power Cable
    • Power Cable, –48V
    • RAID Power Cable
    • Remote Maintenance Center Cable
    • RJ45/RJ45 Cable (CAT-5) (Yellow)
    • RJ45/RJ45 Cable (CAT-5) (Blue)
    • RJ45-to-9 Pin Adapter
    • Row Alarm Cable
    • Router Power Cable
    • RS232
    • Serial I/O Transition Card
    • Serial Interface/Modem Adapter
    • Serial Interface, Terminal, and Printer Adapter
    • Shielded Straight Through Cable (CAT-5)
    • Straight-Through Patch-Panel Cable
    • Switch-to-Frame Ground Cable
    • Terminal/Converter Cable
    • Terminal/Printer Cable
    • Terminal/Server Serial Cable with Flow Control
    • Terminal/Server Serial Port Adapter, NTW
    • Terminal/Server Serial Port Adapter, MRV
    • Terminal/Server Serial Port Adapter, EAGLE/Cyclades
    • Tone and Announcement Server Alarm Cable
• D Part Numbers
  • Overview
  • Cables, Adapters
  • Components
  • Frames, Backplanes, FAPs, and Fans
  • Labels
  • Miscellaneous Parts
  • Power Cords for Peripherals