List of Figures
- 1-1 Base Module and Two Expansion Modules (Front View)
- 1-2 Base Module and Expansion Modules (Rear View)
- 1-3 Front Control Panel Home Screen
- 2-1 Rear View of Sun Rack II (PDU on Right Side)
- 2-2 Base Module Accessory Package Mounting Hardware
- 2-3 Back Rail Position
- 2-4 Back Rails Installed
- 2-5 Front Rail Installation (Left Rail Shown)
- 2-6 Mounting Block for Front Rail (Right Rail Shown)
- 2-7 Rails Installed - Front View
- 2-8 Clip Nut Location for the Base Module
- 2-9 Tab and Rail Engagement
- 2-10 Cable Clip Removal
- 2-11 Expansion Module
- 2-12 Expansion Module Accessory Package Hardware
- 2-13 Library Floor Removal from the Base Module
- 2-14 Expansion Module Clip Nut Installation
- 2-15 Magazine Latches
- 2-16 Library Floor
- 2-17 Floor Secured
- 2-18 Scratch Avoidance
- 2-19 Alignment Tab Seated
- 2-20 Expansion Module Back Rail and Clip Nut
- 2-21 Expansion Module ID Label
- 2-22 Hook and Loop Strap
- 2-23 SL150 Library Rear View
- 2-24 Power Supply
- 2-25 Tape Drive Tray
- 2-26 Initial Cabling Example
- 2-27 Cabling the Expansion Modules
- 6-1 Correct Label Orientation
- 8-1 LEDs on Front of Base Module
- 8-2 LEDs on Rear of Base Module
- 8-3 LEDs on Rear of the Expansion Module
- 10-1 Tape Drive Tray CRU (HP LTO-5)
- 10-2 Power Supply CRU
- 10-3 Rear View of the Front Control Panel
- 10-4 Bullwheel Gear and Robot Lock
- 10-5 Expansion Module FRU
- 10-6 Module Rear Rail Removal
- 10-7 Base Module FRU
- 10-8 Cable Attachment
- A-1 Non-Partitioned One Module Library, Standard Mailslot, and No Reserved Cells
- A-2 Non-Partitioned Two Module Library, Expanded Mailslot, and No Reserved Cells
- A-3 Non-Partitioned 15 Module Library, Standard Mailslot, and Three Reserved Cells