Documentation, Support, and Training
Understanding Switch Specifications
Network Management Connector and Pins
USB Management Connector and Pins
Understanding InfiniBand Cabling
Floor and Underfloor Delivery of InfiniBand Cables
Overhead Delivery of InfiniBand Cables
Verify Shipping Carton Contents
Install the Switch in the Rack
Accessing the Management Controller
Access the Management Controller From the Network Management Port
Access the Management Controller From the USB Management Port
Verifying the InfiniBand Fabric
Discover the InfiniBand Fabric Topology
Perform Diagnostics on the InfiniBand Fabric
Validate the InfiniBand Fabric and Report Errors
Understanding Administrative Commands
Monitoring the InfiniBand Fabric
Controlling the InfiniBand Fabric
Controlling the Subnet Manager
Understanding Oracle ILOM on the Switch
Understanding Oracle ILOM Targets
Installing the Oracle ILOM Firmware
Acquire the Oracle ILOM Firmware Version 1.1.3
Install the Oracle ILOM Firmware Version 1.1.3
Administering Oracle ILOM (CLI)
Accessing Oracle ILOM From the CLI
Switching Between the Oracle ILOM Shell and the Linux Shell
Monitoring Oracle ILOM Targets (CLI)
Controlling Oracle ILOM Targets (CLI)
Upgrading the Switch Firmware Through Oracle ILOM (CLI)
Administering Oracle ILOM (Web)
Access Oracle ILOM From the Web Interface
Monitoring Oracle ILOM Targets (Web)
Controlling Oracle ILOM Targets (Web)
Upgrading the Switch Firmware Through Oracle ILOM (Web)
Accessing the Rear Panel Diagram
Accessing Status Pane Information
Monitoring Parameters and Status
Administering Oracle ILOM (SNMP)
Monitoring Oracle ILOM Targets (SNMP)
Controlling Oracle ILOM Targets (SNMP)
Display the Sensors' State (IPMI)
Display the Sensor Information (IPMI)
Display the System Event Log (IPMI)
Display FRU ID Information (IPMI)
Display Switch Status LED States (IPMI)
Disable the Locator LED (IPMI)
Understanding Oracle ILOM Commands
Understanding Hardware Commands
Linux Shells for Hardware Commands
Understanding InfiniBand Commands
Linux Shells for InfiniBand Commands
Understanding the SUN-DCS-MIB MIB OIDs
Understanding the SUN-ILOM-CONTROL-MIB MIB OIDs
Understanding the SUN-PLATFORM-MIB MIB OIDs
If you have no Subnet Managers other than the one within the management controller, you need not set the Subnet Manager priority. If you have other Subnet Managers in your InfiniBand fabric, you must decide which is to be the primary Subnet Manager. The primary (or master) Subnet Manager has the highest priority. All other Subnet Managers are secondary Subnet Managers, and must have a lower priority.
# enablesm Starting IB Subnet Manager. [ OK ] #
# setsmpriority priority
where priority is 0 (lowest) to 13 (highest). For example, to set the Subnet Manager to priority 13:
# setsmpriority 13 ------------------------------------------------- OpenSM 3.2.6_20090717 Reading Cached Option File: /etc/opensm/opensm.conf Loading Cached Option:routing_engine = ftree Loading Cached Option:sminfo_polling_timeout = 1000 Loading Cached Option:polling_retry_number = 3 Command Line Arguments: Priority = 13 Creating config file template ’/tmp/osm.conf’. Log File: /var/log/opensm.log ------------------------------------------------- #
# disablesm Stopping IB Subnet Manager. [ OK ] # enablesm Starting IB Subnet Manager. [ OK ] #
Switch Reference, setsmpriority command
Switch Reference, enablesm command
Switch Reference, opensm command