Change a SEFOS User Privilege Level
Configure Network Management From the Web Interface
Configure Network Management From the CLI
Log Out of the Oracle ILOM CLI
Configuring the SEFOS Environment
Enable or Disable the Timeout for Line Connections
Configure the Default IP Address
Configure the IP Address for an Interface
Configure the Name of the Configuration File
Enable or Disable Trap Generation on an Interface
Enable or Disable the Incremental Save Flag
Enable or Disable the Auto Save Flag
Save the Configuration to a File
Copy a Configuration File to a Remote Location
Copy a Configuration File From a Remote Location to Flash
Copy a Configuration File From One Remote Location or Flash to Another Remote Location or Flash
Copy a System Log to a Remote Location
Configuring the Switching Feature
Configuring the Routing Feature
Configure Static Unicast Route Entries
Port mirroring monitors the packets of a particular port on another port. The following example shows how to mirror all incoming packets on port 1 to port 2.
See Basic SEFOS Topology for the topology for this task. Type the following commands on the SEFOS-1 switch.
See Connect to SEFOS.
SEFOS-1# configure terminal SEFOS-1(config)# interface vlan 1 SEFOS-1(config-if)# shutdown SEFOS-1(config-if)# ip address 12.0.0.1 255.0.0.0 SEFOS-1(config-if)# no shutdown SEFOS-1(config-if)# end
SEFOS-1# ping 12.0.0.100 Reply Received From :12.0.0.100, TimeTaken : 60 msecs Reply Received From :12.0.0.100, TimeTaken : 100 msecs Reply Received From :12.0.0.100, TimeTaken : 90 msecs --- 12.0.0.100 Ping Statistics --- 3 Packets Transmitted, 3 Packets Received, 0% Packets Loss
The ping reply from host A to the switch is not captured at port 2, which is connected to the packet capturing device prior to the port-mirroring configuration.
SEFOS-1# configure terminal
SEFOS-1(config)# monitor session destination interface extreme-ethernet 0/2
SEFOS-1(config)# monitor session source interface extreme-ethernet 0/1 rx
SEFOS-1(config-if)# end
SEFOS-1# show port-monitoring Port Monitoring is enabled Monitor Port : Ex0/2 Port Ingress-Monitoring Egress-Monitoring ---- ------------------ ----------------- Ex0/1 Enabled Disabled ...
SEFOS-1# ping 12.0.0.100
# tcpdump -xx -n -i eth3 icmp ... listening on eth3, link-type EN10MB (Ethernet), capture size 96 bytes 17:09:58.595583 IP 12.0.0.100 > 12.0.0.1: ICMP echo reply, id 0, seq 1, length 40 ... 0x0010: 003c 68e6 4000 ff01 fa75 0c00 0064 0c00 17:09:58.617899 IP 12.0.0.100 > 12.0.0.1: ICMP echo reply, id 0, seq 2, length 40... 0x0030: a5a5 a5a5 a5a5 a5a5 a5a5 a5a5 a5a5 a5a5 17:09:58.698280 IP 12.0.0.100 > 12.0.0.1: ICMP echo reply, id 0, seq 3, length 40...