Oracle^® X6 Series Servers Administration Guide

Set SP Host Power Policy at Boot

1. To set a power-on policy in the Oracle ILOM web interface, perform the following steps:
   1. Log in to the Oracle ILOM web interface.

      For instructions, see Accessing Oracle ILOM.

   2. In the navigation pane, click System Management > Policy.
   3. In the Service Processor Policies table, select one of the following policies:
      • Auto power-on host on boot
      • Set host power to last power state on boot

      The power on policies are mutually exclusive, that is, only one can be enabled at a time. For more information about each policy, click the More Details link at the top of the page.

   4. In the Actions drop-down list, select Enable.
2. To set a power-on policy in the Oracle ILOM command-line interface (CLI), perform the following steps:
   1. Log in to the Oracle ILOM CLI.

      For instructions, see Accessing Oracle ILOM.

   2. Use one of the following commands:
      • set /SP/policy HOST_AUTO_POWER_ON=enabled
      • set /SP/policy HOST_LAST_POWER_STATE=enabled

      The power-on policies are mutually exclusive, that is, only one can be enabled at a time. For more information about each policy, see the Related Information section following this procedure.

Related Information

• Power-On and Cooling-Down Policies Configurable from the Server SP, Oracle ILOM Administrator's Guide for Configuration and Maintenance, Firmware Release 3.2.x