Setting defaults ensures that the server is operating with a known-good configuration.
Any changes you make in the BIOS Setup Utility using the F2 key are permanent until the next time you change them.
Before You Begin
Ensure that your server meets the following requirements:
The server is equipped with a hard disk drive (HDD) or solid state drive (SSD).
The HDD or SSD is properly installed in the server. For instructions, refer to your service manual.
For instructions, see Accessing the BIOS Setup Utility.
A message appears prompting you to continue this operation by selecting OK or to cancel this operation by selecting CANCEL.
Alternatively, you can select Save and Reset from the Exit menu.