Understanding the Installation
Understanding Management and Power Cabling
Single-Switch Location Guidelines
Attach the Rails to the Switch
Attach Telco Adapters to the Rack Slides
Attach the Rack Slides to the Rack
Install the Switch Into the Rack
Install the Air Duct and Front Support
Attach Data and Management Cables
Prepare the Front Support and Small Air Duct
Verify the DHCP-Assigned IP Address and Host Name
Log Into the Oracle ILOM Web (NET MGT)
Log Into the Oracle ILOM CLI (NET MGT)
Log Into the Oracle ILOM CLI (SER MGT)
Change a SEFOS User Privilege Level
Configure Network Management From the Web Interface
Configure Network Management From the CLI
Log Out of the Oracle ILOM CLI
Configuring the SEFOS Environment
Configuring the Switching Feature
Configuring the Routing Feature
Check Switch Status (Oracle ILOM)
-> cd SP/network
Note - By default, the switch uses DHCP as the IP discovery mode. To use static as the IP discovery mode, use the following command.
-> set ipdiscovery = static
-> set pendingipaddress=IP_address Set 'pendingipaddress' to 'IP_address'
-> set pendingipgateway=IP_address Set 'pendingipgateway' to 'IP_address'
-> set pendingipnetmask=netmask Set 'pendingipnetmask' to 'n.n.n.n'
-> set commitpending=true Set 'commitpending' to 'true'
-> set state=enabled Set 'state' to 'enabled'
The show command information about the switch, including its IP address.
For example:
-> show /SP/network Targets: Properties: type = Network Configuration commitpending = (Cannot show property) ipaddress = 10.7.59.97 ipdiscovery = static ipgateway = 10.7.59.254 ipnetmask = 255.255.255.0 macaddress = 00:14:4f:6C:5D:E8 pendingipaddress = 10.7.59.97 pendingipdiscovery = static pendingipgateway = 10.7.59.254 pendingipnetmask = 255.255.255.0 state = enabled Commands: cd set show ->
Log into the Oracle ILOM web interface.
Log into the Oracle ILOM CLI.