Remove the Top Cover
 | Caution - Removing the top cover without properly powering down the server and disconnecting the AC power cords from the power supplies results in a chassis intrusion switch failure. This failure causes the server to be immediately powered off. Any changes you make to the DIMM configurations will not be properly reflected in the service processor's inventory until you replace the top cover. |
- Ensure that the AC power cords are disconnected from the server power supplies.
- Press the green button to release the top cover (panel 1).
- Slide the cover towards the rear of the server chassis about 0.5 inch (12 mm).
- Lift up and remove the top cover (panel 2).