-
Lower the drive backplane into the server, and then position it under the
spring tab to engage the standoff hooks.
The standoff hooks fit into small openings in the drive backplane.
Ensure that ribbon cables are clear of the drive backplane.
-
Using a No. 2 Phillips screwdriver, install and tighten the spring-mounted
screw (on the power supply side of the server) to secure the drive backplane to
the chassis.
-
Reconnect the cables to the drive backplane.
-
Reconnect the auxiliary signal cable to the drive backplane.
-
Reconnect the power cable to the drive backplane.
-
Reconnect the two NVMe cables to the drive backplane.
Attach connectors to the original locations on the drive
backplane.
-
Reconnect the two SAS cables to the drive backplane.
-
Return the server to operation.
-
If removed, install the fan modules.
See Install a Fan Module.
-
Install the fan cover, and close the fan door.
See Replace the Fan Cover.
-
Fully install all storage drives you disengaged or removed.
See Install a Drive or Drive Filler.
-
Return the server to the normal operating position.
See Return the Server to the Normal Operating Position.
-
Reconnect the power cords to the power supplies, and power on the
server.
See Attach Power Cords and
Power On the Server (Oracle ILOM) or Power On the Server (System Power Button). Verify that the power supply
AC OK LED is lit.
Note - Authorized service personnel might need to reprogram
the product serial number on the drive backplane. This number is
used for service entitlement and warranty coverage. The correct
product serial number is located on a label on the front of the
chassis.
-
Use the Oracle ILOM show faulty command to verify that the
fault has been cleared.
See Identify Faulted Components for more information on using the show
faulty command.