Remove a PCIe Card or Filler
| Caution - This procedure requires
that you handle components that are sensitive to ESD. This sensitivity
can cause the component to fail. To avoid damage, ensure that you
follow antistatic practices as described in ESD Measures. |
You can perform this procedure. The server must be completely powered down before performing
this procedure. See Component Service Categories for more information about cold-service
procedures.
-
Prepare for servicing.
-
Attach an antistatic wrist strap.
-
Power off the server and disconnect all power cords from the server
power supplies.
See Removing
Power From the Server.
-
Extend the server to the maintenance position.
See Extend
the Server to the Service Position.
-
Remove the top cover.
See Remove
the Top Cover.
-
Locate the PCIe card or filler that you want to remove.
See Rear Panel
Components for information about PCIe slots and their
locations.
If you are removing a PCIe filler, go to Step 6.
-
Note the slot location for each PCIe card you plan to remove.
-
Unplug all data cables from the PCIe card.
Note the location of all cables for reinstallation later.
If you are removing the on board SAS disk controller, installled in slot 7,
follow these steps:
-
Remove the cable from rear of card.
-
Remove the screw from top of the standoff.
-
Lift the PCIe card off motherboard.
-
Remove any transceivers from the PCIe card before removing the card.
-
Remove the PCIe card by completing the following tasks.
-
Rotate the PCIe card locking mechanism (panel 1).
-
Carefully lift the PCIe card or filler from the card slot (panel 2).
-
Replace with another PCIe card or filler before the server is connected to
power again.
See Install a PCIe
Card or Filler.