FCode-Based RAID Utility Commands
These commands are provided through an FCode-based RAID utility provided with the on-board controllers. You can enter these commands at the OpenBoot prompt. For details on preparing to enter these commands to affect a specific controller, see Prepare to Create a RAID Hardware Volume (FCode-based RAID Utility).
|
|
show-children
|
Lists all connected physical drives and logical volumes.
|
show-volumes
|
Lists all connected logical volumes in detail.
|
create-raid0-volume
|
Creates a RAID 0 volume (minimum two targets).
|
create-raid1-volume
|
Creates a RAID 1 volume (exactly two targets).
|
create-raid1e-volume
|
Creates a RAID 1e volume for an odd number of target drives (minimum three).
Note -
If you specify an even number of target drives (minimum four) with this command, those drives will be configured and identified as RAID 10. For an even number of drives, RAID 1e is the functional equivalent of RAID 10.
|
create-raid10-volume
|
Creates a RAID 10 volume for an even number of target drives (minimum four).
For any other number of target drives, this command fails.
|
delete-volume
|
Deletes a RAID volume.
|
activate-volume
|
Reactivates a RAID volume after the motherboard has been replaced.
|
|