JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Sun Network 10GbE Switch 72p

User’s Guide

search filter icon
search icon

Document Information

Using This Documentation

Product Notes

Related Documentation

CLI Command Modes


Support and Accessibility

Understanding the Switch

Switch Overview

Front Panel Components

Rear Panel Components

Confirming Switch Specifications

Physical Specifications

Electrical Specifications

Environmental Specifications

Acoustic Noise Emissions

Installing the Switch

Preparing to Install the Switch

Verify Shipping Kit Contents

Antistatic Precautions

Install the Switch in the Rack

Connecting Management Cables

Management Cable Requirements


Connect the NET MGT Cable


Connect the SER MGT Cable

Powering On the Switch

Power Cord Specifications

Power On the Switch

Connecting Ethernet Cables

QSFP Cables

SFP+ Cables

Splitter Cables

Ethernet Cable Cautions

Connect Ethernet Cables

Finish the Switch Installation

Administering the Switch

Connecting to the Service Processor

Oracle ILOM Overview

Oracle ILOM Features Not Supported

Verify the DHCP-Assigned IP Address and Host Name

Configure Network Management From CLI (SER MGT)

Log Into Oracle ILOM Web (NET MGT)

Log Into Oracle ILOM CLI (NET MGT)

Log Into Oracle ILOM CLI (SER MGT)

SER MGT Port Configuration Parameters

Configure Network Management From Web

Configure Network Management From CLI (NET MGT)

Log Out of ILOM

Configuring SEFOS User Privileges

Create a SEFOS User

Change a SEFOS User Privilege Level

Update the Firmware

Connecting to SEFOS

SEFOS Overview

Connect to SEFOS

Disconnect From SEFOS

Servicing the Switch

Troubleshooting the Switch

Identifying LEDs

Sensors Overview

Check Switch Status (LEDs)

Check Switch Status (Oracle ILOM)

Component Sensor Targets

Motherboard Sensor Targets

Understanding Service Procedures

Tools Needed for Service

Replaceable Components

Servicing Power Supplies

Power Off a Power Supply

Remove a Power Supply

Install a Power Supply

Power On a Power Supply

Servicing Fans

Remove a Fan

Install a Fan

Servicing Ethernet Cables

Remove an Ethernet Cable

Install an Ethernet Cable

Servicing the Battery

Remove the Battery

Install the Battery



Remove a Power Supply

  1. Identify which power supply to remove and power off the power supply.

    See Power Off a Power Supply.

  2. Press and hold the release tab to the left and pull on the handle of the power supply.
    image:Figure shows the power supply being released
  3. Continue to pull the power supply handle to remove it from the switch.
    image:Figure shows the power supply being removed
  4. Set the power supply aside.
  5. Install a replacement power supply.

    See Install a Power Supply.

Related Information