Caution - Ensure that all power is removed from the server before removing or installing the motherboard assembly. You must disconnect the power cables from the system before performing these procedures.
Caution - These procedures require that you handle components that are sensitive to ESD. This sensitivity can cause the component to fail. To avoid damage, ensure that you follow antistatic practices as described in ESD Measures.
After you replace the SP, restoring the SP configuration will be easier if you had previously saved the configuration using the Oracle ILOM backup utility. If possible, back up the Oracle ILOM configuration before removing the SP. Refer to the Oracle ILOM documentation for instructions on backing up and restoring the Oracle ILOM configuration.To retain the same version of the system firmware with the new SP, note the current version before removing the SP.
Replacing the SP is a cold service procedure that must be performed by qualified service personnel. The system must be completely powered down before performing this procedure. See Cold Service, Replaceable by Authorized Service Personnel for more information about this category of service procedures.
Before You Begin
The amber SP OK/Fault LED on the front panel will be lit when a SP fault is detected.
See Internal Components.
Note - If you are removing the SP because you are replacing the motherboard, set the SP aside as you will need to reinstall it on the new motherboard.