JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Oracle Switch ES1-24

Installation Guide
Oracle Technology Network
Library
PDF
Print View
Feedback
search filter icon
search icon

Document Information

Using This Documentation

Product Notes

Related Documentation

CLI Command Modes

Feedback

Support and Accessibility

Understanding the Installation

Installation Task Overview

Front Panel Components

Rear Panel Components

Confirming Specifications

Physical Specifications

Electrical Specifications

Environmental Specifications

Understanding Cabling

Understanding Management and Power Cabling

Management Connection Overview

NET MGT Port

SER MGT Port

Power Cord Specifications

Understanding Data Cabling

SFP+ Data Cable Overview

10GBASE-T Data Cable Overview

Data Cable Cautions

Data Cable Guidelines

Single-Switch Location Guidelines

Preparing for Installation

ESD Precautions

Tools Needed for Installation

Verify Switch Kit Contents

Verify Rack Rail Kit Contents

Assemble an SFP+ Data Cable

Route Cables

Installing the Switch

Assemble a Filler

Attach the Rails to the Switch

Attach Telco Adapters to the Rack Slides

Attach the Rack Slides to the Rack

Install the Switch Into the Rack

Attach Power Cords

Install the Air Duct and Front Support

Attach Data and Management Cables

Prepare the Front Support and Small Air Duct

Powering On the Switch

Power On the Switch

Oracle ILOM Overview

Verify the DHCP-Assigned IP Address and Host Name

Configure Network Management From the CLI (SER MGT)

Log Into the Oracle ILOM Web (NET MGT)

Log Into the Oracle ILOM CLI (NET MGT)

Log Into the Oracle ILOM CLI (SER MGT)

Glossary

Index

Data Cable Cautions

Caution

Caution - Data cables with laser transceivers must be Class I.

image:Do not step icon
Do not step on the cable or connectors. Plan cable paths away from foot traffic or rolling loads.
image:Do not pull icon.
Do not pull the cable out of the shipping box, through any opening, or around any corners. Unroll the cable as you lay it down and move it through turns.
image:Do not bend icon.
Do not bend the cables to a radius tighter than 85 mm (3.4 inches). Ensure that cable turns are as wide as possible.
image:Do not pack icon.
Do not pack the cable to fit a tight space. Use an alternative cable route.
image:Do not drop icon.
Do not drop the cable or connectors from any height. Gently set the cable down, resting the cable connectors on a stable surface.
image:Do not drag icon.
Do not drag the cable or its connectors over any surface. Carry the entire cable to and from the points of connection.
image:Do not force icon.
Do not force the cable connector into the receptacle by pushing on the cable. Apply connection or disconnection forces at the connector only.
Related Information
Copyright © 2013, Oracle and/or its affiliates. All rights reserved. Legal Notices
Previous Next