Caution - Ensure that all power is removed from the server before removing or installing the motherboard assembly. You must disconnect the power cables from the server before performing these procedures. |
Caution - These procedures require that you handle components that are sensitive to ESD. This sensitivity can cause the component to fail. To avoid damage, ensure that you follow antistatic practices as described in ESD Measures. |
You can perform this cold-service procedure. The server must be completely powered down before performing this procedure. See Component Service Categories for more information about this category of service procedures.
The amber SP OK/Fault LED on the front panel will be lit when an SPM fault is detected.
After you replace the SPM, restoring the SPM configuration will be easier if you previously saved the configuration using the Oracle ILOM backup utility. Refer to the Oracle ILOM documentation for instructions on backing up and restoring the Oracle ILOM configuration.
To retain the same version of the system firmware with the new SPM, note the current version before removing the SPM.
See Remove the Top Cover.
See Install the SPM.