Documentation, Support, and Training
Understanding ILOM on the Switch
Administering ILOM (Web Interface)
Understanding Service Procedures
Inspect the Power Supply Hardware
Inspect the Power Supply Connectors
Servicing the Fabric Cards and Fabric Card Fillers
Inspect the Fabric Card Chassis
Inspect the Fabric Card Retainer Bolts
Inspect the Fabric Card XBOW Connectors
Remove a Fabric Card or Fabric Card Filler
Install a Fabric Card or Fabric Card Filler
Servicing the InfiniBand Cables
Inspecting the InfiniBand Cables
Inspect the InfiniBand Cable Hardware
Inspect the InfiniBand Cable Connectors
Inspect the Line Card Retainer Bolts
Inspect the Line Card XBOW Connectors
Inspect the Line Card CXP Connectors
Doing Supportive Software Tasks
Identify the prerequisite and subsequent tasks you must perform in conjunction with this procedure, to achieve a goal.
See the table in Servicing the Power Supplies.
Inspect the replacement power supply.
Inspect the slot where the power supply will install for debris and loose gasketing.
![]() | Caution - You must remove any debris or gasketing material from the power supply slot prior to installing the power supply. Failure to clean the slot might result in a power supply fault or damage to the power supply or switch chassis upon installation of the power supply or attachment of the power cord. |
Press the button and swing down the release handle.
Orient the power supply with the handle on the bottom and the connectors to the rear.
Slide the power supply into the open slot, pushing the power supply in until the release handle moves.
Raise the release handle up until it clicks to secure the power supply into the chassis.
Power on the power supply.