Documentation, Support, and Training
Understanding ILOM on the Switch
Administering ILOM (Web Interface)
Understanding Service Procedures
Inspect the Power Supply Hardware
Inspect the Power Supply Connectors
Servicing the Fabric Cards and Fabric Card Fillers
Inspect the Fabric Card Chassis
Inspect the Fabric Card Retainer Bolts
Inspect the Fabric Card XBOW Connectors
Remove a Fabric Card or Fabric Card Filler
Install a Fabric Card or Fabric Card Filler
Servicing the InfiniBand Cables
Inspecting the InfiniBand Cables
Inspect the InfiniBand Cable Hardware
Inspect the InfiniBand Cable Connectors
Inspect the Line Card Retainer Bolts
Inspect the Line Card XBOW Connectors
Inspect the Line Card CXP Connectors
Doing Supportive Software Tasks
Note - Use the table in Component Addressing to determine the slot number or IPMB address of your component.
Identify the prerequisite and subsequent tasks you must perform in conjunction with this procedure, to achieve a goal.
See the table in Servicing the Power Supplies.
Determine which power supply is to be removed.
Use the disablepsu command to bring the power supply to a standby state.
For example, to disable power supply 0:
# disablepsu 0 PSU 0, 12 V is off #
Note - Use the table in Component Addressing to determine the slot number or IPMB address of your component.
At the rear of the chassis, remove the respective power cord.
Note - The power cord for power supply 0 is on the right side. The power cord for power supply 3 is of the left side.
The power supply is completely powered off.
Remove the power supply.
Switch Reference, disablepsu command