Documentation, Support, and Training
Understanding ILOM on the Switch
Administering ILOM (Web Interface)
Understanding Service Procedures
Inspect the Power Supply Hardware
Inspect the Power Supply Connectors
Servicing the Fabric Cards and Fabric Card Fillers
Inspect the Fabric Card Chassis
Inspect the Fabric Card Retainer Bolts
Inspect the Fabric Card XBOW Connectors
Remove a Fabric Card or Fabric Card Filler
Install a Fabric Card or Fabric Card Filler
Servicing the InfiniBand Cables
Inspecting the InfiniBand Cables
Inspect the InfiniBand Cable Hardware
Inspect the InfiniBand Cable Connectors
Inspect the Line Card Retainer Bolts
Inspect the Line Card XBOW Connectors
Inspect the Line Card CXP Connectors
Doing Supportive Software Tasks
Identify the prerequisite and subsequent tasks you must perform in conjunction with this procedure, to achieve a goal.
See the table in Servicing the CMCs.
Inspect the replacement CMC.
See Inspecting the CMCs.
Inspect the slot where the CMC will install to be clean and free of debris.
Squeeze the latches on the release levers and swing the levers outward.
Set the back of the CMC onto the rails inside the chassis.
Carefully slide the CMC into the chassis until the release levers move.
Swing the release levers inward to secure the CMC into the chassis.
Tighten the thumbscrews above the release levers.
Note - Make the thumbscrews only finger tight. Do not use a screwdriver.
Reconnect the cables you removed previously to the front panel.
Power on the CMC.
See Power On a CMC.