To Connect the Copper Cables
Use only SFP+ direct attach twinax cables approved
by Oracle. The following table lists the part numbers for the approved
twinax copper cables.
|
|
|
SN-TWX-0101 |
SG-XSWBROSFP-1MIPK |
Brocade Twinax, 1 Meter, 1 Pack, SN |
SN-TWX-0301 |
SG-XSWBROSFP-3M1PK |
Brocade Twinax, 3 Meter, 1 Pack, SN |
SN-TWX-0501 |
SG-XSWBROSFP-5M1PK |
Brocade Twinax, 5 Meter, 1 Pack, SN |
|
Note -
If you are connecting this Converged Network Adapter to a Cisco FCoE
switch, do not use the cables listed in this section. Instead, use OM-3
twin-ax cables that are supported by Cisco. Check with Cisco for the
recommended twin-ax cables to use with the specific Cisco switch that you
are using. If any issues occur due to the use of Cisco cables, contact Cisco
support for resolution.
- Insert
one end of the copper cable, or cables, into an empty SFP+ cage
on the adapter.
Confirm that the cable is fully inserted and engaged.
The following figure shows how to connect the dual-port adapter with copper cables.
- Insert the other end of the copper
cable, or cables, into an empty SFP+ cage on the FCoE switch.
Note -
Link Aggregation Control Protocol (LACP) cannot be used on the sam
port as FCoE or iSCSI.