Understanding the Installation
Understanding Management and Power Cabling
Management Connection Overview
Single-Switch Location Guidelines
Attach the Rails to the Switch
Attach Telco Adapters to the Rack Slides
Attach the Rack Slides to the Rack
Install the Switch Into the Rack
Install the Air Duct and Front Support
Attach Data and Management Cables
Prepare the Front Support and Small Air Duct
Verify the DHCP-Assigned IP Address and Host Name
Configure Network Management From the CLI (SER MGT)
Log Into the Oracle ILOM Web (NET MGT)
Log Into the Oracle ILOM CLI (NET MGT)
Log Into the Oracle ILOM CLI (SER MGT)
Change a SEFOS User Privilege Level
Configure Network Management From the Web Interface
Configure Network Management From the CLI
Log Out of the Oracle ILOM CLI
Configuring the SEFOS Environment
Configuring the Switching Feature
Configuring the Routing Feature
Check Switch Status (Oracle ILOM)
The SER MGT port is an RJ45 connector that provides RS-232 access to the SEFOS and Oracle ILOM CLI interfaces running on the SP. The port is located at the lower left corner of the switch rear panel. See Front Panel Components.
The serial device must be configured to these parameters:
9600 baud (default, can be set to any standard rate up to 57600)
8N1: eight data bits, no parity, one stop bit
Software flow control (XON/XOFF) disabled
The figure and table describe the pinouts of the SER MGT connector.
|