Use the clzonecluster command to launch an interactive utility to configure a solaris10 or labeled brand zone cluster from the Unified Archive. The clzonecluster configure utility lets you specify a recovery archive or a clone archive.
If you prefer to use the command line rather than the interactive utility to configure a zone cluster from an archive, use the clzonecluster configure –f command-file command. See the clzonecluster (1CL) man page for more information.
phys-schost# archiveadm create -r archive-location
Use the create command to create a clone archive or the –r option to create a recovery archive. For more information on using the archiveadm command, see the archiveadm (1M) man page.
phys-schost-1# clzonecluster configure zone-cluster-name
The clzonecluster configure zone-cluster-name command launches the interactive utility, where you can specify create -a archive [other-options-such-as-"-x"]. The archive can be either a clone archive or a recovery archive.
The configure subcommand uses the zonecfg command to configure a zone on each specified machine. The configure subcommand lets you specify properties that apply to each node of the zone cluster. These properties have the same meaning as established by the zonecfg command for individual zones. The configure subcommand supports the configuration of properties that are unknown to the zonecfg command. The configure subcommand launches an interactive shell if you do not specify the –foption. The –f option takes a command file as its argument. The configure subcommand uses this file to create or modify zone clusters non-interactively.