Go to main content
Oracle® Server X6-2 Installation Guide

Exit Print View

Updated: October 2016
 
 

Mark the Rackmount Location

Identify the location in the rack where you want to place the server. The server requires one rack unit (1U). Use the rackmount installation card to identify the correct mounting holes for the slide-rails.


Note -  Load the rack from bottom to top.
  1. Ensure that there is at least 1 rack unit (1U) of vertical space in the rack cabinet to install the server.

    See Rack Requirements.

  2. Place the rackmount installation card against the front rails.

    The bottom edge of the card corresponds to the bottom edge of the server. Measure up from the bottom of the installation card.


    image:Figure showing the installation card being used for rackmount                             location.
  3. Mark the mounting holes for the front slide-rails.
  4. Mark the mounting holes for the rear slide-rails.

Related Information