SNMP Properties
Table 93 SNMP Properties
|
|
Version
|
Toggles between v1/2c and v3.
|
Community name
|
Toggles between public and user-input. If you select user-input,
you must also enter a community name. If you select v3, this
property is not available.
|
Authorized network/subnet
|
Enter an appropriate IPv4 address and subnet (integers from 0-32).
If you select v3, this property is not available.
|
Appliance contact
|
Enter an appropriate appliance contact.
|
Username/password
|
Enter a valid username (max 501 characters) and password (8-501
characters). If you select v1/2c, this property is not
available.
|
Authentication
|
Toggles between MD5 and SHA authentication algorithms. If you
select v1/2c, this property is not available.
|
Privacy
|
Toggles between None and DES encryption algorithm. If you select
v1/2c, this property is not available.
|
Engine ID
|
The EngineID value hashed by snmpd. If SNMP was not previously
enabled, the label shows “0x000”.
|
Trap destinations
|
Lets you add IPv4 addresses. Use the “+” and
“-” buttons to add or remove addresses.
|
|
The SNMP service also provides the MIB-II location string. This property is sourced
from the System Identity
configuration.