Oracle^® ILOM Protocol Management Reference SNMP and IPMI Firmware Release 4.0.x

Set the IPMI State and Session Properties (Web)

Before You Begin

• The IPMI state property in Oracle ILOM is enabled by default.

• As of Oracle ILOM firmware 3.2.8, IPMI Session properties are enabled for TLS and IPMI v2.0. The property for IPMI v1.5 Sessions is disabled.

• Admin (a) role privileges are required to change the IPMI state or session properties in Oracle ILOM.

• If FIPS mode is enabled in Oracle ILOM, the IPMI v1.5 session property cannot be enabled. For additional information about FIPS mode, see Operating Oracle ILOM in FIPS Compliance Mode in Oracle ILOM Administrator’s Guide for Configuration and Maintenance Firmware Release 4.0.x

Follow these steps to set the IPMI state and sessions properties using the Oracle ILOM web interface:

1. Log in to the Oracle ILOM web interface using an account with admin (a) role privileges.
2. Click ILOM Administration → Management Access > IPMI.

   The IPMI page appears.

3. In the IPMI page, enable or disable the IPMI State check box and the applicable sessions property check boxes for TLS, IPMI v2.0 and IPMI v1.5.

   ---

   Note -  If the IPMI Service State property is disabled, system management information using the IPMItool utility is not accessible.

   ---

   ---

   Note -  For a higher level of security, the checkboxes for IPMI 1.5 sessions and IPM 2.0 sessions should be disabled.

   ---

   ---

   Note -  If FIBS mode is enabled, the IPMI v1.5 session property cannot be enabled. For more details about FIPS mode, click the Details link on the Management Access > FIPS page.

   ---