Power Off and Remove the Blade Server

---

Caution - Do not place blade servers on top of an antistatic bag unless the outside of the bag has antistatic protective properties.

---

1. Power off the blade server.
2. Move the front cable management bracket to the lower position.
   
3. Remove all cables from the blade server.
4. Loosen the locking screws to release the blade server from the ATCA shelf.
5. When the blue Hot-Swap LED lights steadily, release the upper latch and the lower latch at the same time to unseat the blade server from the connectors.
6. Remove the blade server from the ATCA shelf and place the blade server on an antistatic mat.
7. Remove any optional components installed on the blade.

   See Removing Optional Components.

8. Install a replacement blade server or a filler panel.

   See Installing the Blade Server.

   ---

   Note - If transferring the same optional components from the old blade server to the new one, install optional components before installing the replacement blade server.

   ---

   ---

   Caution - Failure to cover all open slots with filler panels can negatively impact the cooling of the system.

   ---

Related Information

• Removing Optional Components

• Return a Blade Server

• Preparing to Install the Blade Server

• Installing the Blade Server

• Safety Requirements