| Skip Navigation Links | |
| Exit Print View | |
|
Netra SPARC T3-1BA Blade Server User’s Guide |
Documentation, Support, and Training
Evaluating Product Compatibility
Form-Factor Physical Characteristics
Warranty and Technical Support
System Requirements and Options
Installing Optional Components
Preparing to Install the Blade Server
Power and Thermal Distribution
Required Cooling and Blade Impedance Curve
Local Network IP Addresses and Host Names
Connect the External I/O Cables
Connect Cables to a System Console Running the Oracle Solaris OS
Connect Cables to a System Console Not Running Oracle Solaris OS
Insert and Latch the Blade Server
Software and Firmware Upgrades
Software and Firmware Upgrades
Firmware and Blade Server Management
Creating a Boot Disk Server and Adding Clients
Create a Boot Server for Diskless Clients
Compact Flash Formatting for the Oracle Solaris OS
Multiplex Configuration of Zones 2 and 3
Advanced Rear Transition Module Connectors (Zone 3)
Locate Base MAC Address on Blade Server
Configuring and Using Serial Over LAN
Shut Down OS and Deactivate the Blade Server
Power Off and Remove the Blade Server
The following applies only to the Oracle Netra CT900 chassis. Refer to the Netra CT900 Server Upgrade Guide for detailed information.
The Netra CT900 server fan tray upgrade kit must be installed in the chassis before the blade server is installed. This fan tray upgrade is required to provide adequate cooling and prevent the system from overheating or shutting down due to an over temperature condition that can occur with older or mismatched fan trays.
Note - This component is hot-swappable and customer-replaceable.
# clia fruinfo fan_tray 1 | grep "Product Part"
Refer to the Netra CT900 Server Upgrade Guide for detailed information.
http://www.oracle.com/pls/topic/lookup?ctx=ct900[amp ]id=homepage
Note - Be careful not to disconnect adjacent fans.
 | Caution - If you are hot-swapping this component, do not keep the fan tray access cover open for more than 60 seconds at a time on a running system, otherwise the system might overheat. Remove and replace only one fan module at a time. |
|