Sun Flash Accelerator F40 PCIe Card Overview
About the Sun Flash Accelerator F40 PCIe Card
Card Software and Firmware Components
Preparing the Card for Installation
Perform ESD Prevention Measures
Update the Host Operating System
Installing the Card Into a Server
Remove an Existing Card From a Server
Servicing the Card Using the ddcli Utility
Access Text Menu Interface in ddcli Utility
Access Command Line Interface (CLI) in ddcli Utility
Show the Vital Product Data Command
Troubleshooting Using Card LEDs
The -listall command identifies all Sun Flash Accelerator F40 PCIe Cards installed in a server.
The following information is displayed with the -listall command:
Card ID number
Card name
Card flash package version
PCI address
Text Menu Interface Usage: The ddcli utility lists seven commands. Type 1 to list all installed Sun Flash Accelerator F40 PCIe Cards installed in a server, as shown in the following example:
# ddcli 1. List WarpDrive Information 2. Update Flash Package 3. Display WarpDrive Health 4. Locate WarpDrive 5. Format WarpDrive 6. Show Vital Product Data 7. Extract SMART Logs Select Operation [1-7 or 0:Quit]: 1
Command Line Interface Usage: Enter the following line of text in the CLI to run the -listall command: ddcli -listall
The -listall command runs without any command line parameter. You need not specify the -c option on the command line.
Sample Output: When the -listall command runs, the ddcli utility outputs the following text. Two Sun Flash Accelerator F40 PCIe Cards are shown in the following example:
ID WarpDrive Package Version PCI Address -- --------- --------------- ----------- 1 ELP-4x100-4d-n 06.05.10.00 00:09:00:00 2 ELP-4x100-4d-n 06.05.10.00 00:05:00:00