Use the following commands to configure or unconfigure a SATA device:
To configure a SATA controller: cfgadm -c configure controller
To unconfigure a SATA controller:cfgadm -c unconfigure controller – unconfigures a SATA controller.
In both commands, controller refers to the SATA HBA Ap_Id, such as sata0/0. For more information about the Ap_Id, see About Attachment Point Identification.
The following example configures the c7t0d0 device.
# cfgadm -c configure c7t0d0
The following example shows the state of the c7t0d0 device after it has been configured.
# cfgadm | grep sata0/0 sata0/0 disk connected unconfigured ok