Oracle^® Storage 12 Gb/s SAS PCIe RAID HBA, Internal Installation Guide For HBA Models 7110116 and 7110117

To Install the HBA

1. Attach an antistatic wrist strap and remove the HBA from its protective bag.

   See Observing ESD and Handling Precautions.

2. If a removable memory option is present, ensure that the module is seated firmly in the dual-inline memory module (DIMM) socket.

   ---

   Note -  This HBA has on-board, 72-bit direct DDR-3 memory.

   ---

3. Refer to the installation guide or service manual for your particular system for instructions on how to locate an available PCIe slot in the system.
4. Align the PCIe bus connector of the HBA to the PCIe slot.

   ---

   Note -  Some PCIe slots support PCIe graphics cards only; if the HBA is installed in one of those PCIe slots, the HBA will not function.

   ---

5. Press down gently and firmly to seat the HBA in the PCIe slot, and then secure the bracket to the system chassis with the retention clip (see the following figure).
   

   Callout Description 1 Retention clip 2 Press down here, on the edge by the internal ports. 3 PCIe slot 4 Motherboard

   ---

   Note -  The configuration of the enclosure might not be the same as shown in this illustration.

   ---