Configure POST

Language:

Log in to Oracle ILOM.
See Log In to Oracle ILOM (Service).

Set the virtual keyswitch to the value that corresponds to the POST configuration you want to run.

This example sets the virtual keyswitch default_level to min, which configures POST to run according to other parameter values.

-> set /HOST default_level=min
Set default_level to min

For possible values for the default_level parameter, type:

-> help /HOST diag

/HOST/diag : Manage Host Power On Self Test Diagnostics

Targets:

Properties:
default_level : Diag level in the default cause (no error or hw change)
default_level : Possible values = off, min, max
default_level : User role required for set = r

default_verbosity : Diag verbosity in the default cause (no error or hw
                            change)
default_verbosity : Possible values = none, min, normal, max
default_verbosity : User role required for set = r

error_level : Diag level when running after an error reset
error_level : Possible values = off, min, max
error_level : User role required for set = r

error_verbosity : Diag verbosity when running after an error reset
error_verbosity : Possible values = none, min, normal, max
error_verbosity : User role required for set = r

hw_change_level : Diag level when running after a hw change
hw_change_level : Possible values = off, min, max
hw_change_level : User role required for set = r

hw_change_verbosity : Diag verbosity when running after a hw change
hw_change_verbosity : Possible values = none, min, normal, max
hw_change_verbosity : User role required for set = r

->

Note - When the verbosity value is set to none, the console might not display any POST test status for extended periods of time on certain configurations.

(Optional) Set the virtual keyswitch to determine the diagnostic level after an error reset and after a hardware change.
To set error_level, to max, and to set hw_change_level to max, type:
```
-> set /HOST/diag error_level=max
-> set /HOST/diag hw_change_level=max
```
Refer to the section on setting the SPARC host keyswitch state in the Oracle ILOM Administrator’s Guide for Configuration and Maintenance Firmware Release 3.2.x for a description of parameters and values.

View the current values for settings.

For example:

-> show /HOST/diag
 
/HOST/diag
   Targets:
 
   Properties:
        default_level = off
        default_verbosity = normal
        error_level = max
        error_verbosity = normal
        hw_change_level = max
        hw_change_verbosity = normal

 
   Commands:
        cd
        set
        show
->

SPARC T7-1 Server Service Manual

Configure POST

Related Information