Return the Server to the Normal Operating Position
 | Caution - The chassis is heavy. To avoid personal injury, use two people to lift the server and set it in the rack. |
- Release
the slide rails from the fully extended position by pushing the
release tabs on the side of each rail.
- While pushing on the release
tabs, slowly push the server into the rack.
Ensure that the cables do not get in the way.
- Reconnect the cables to the rear
of the server.
If the CMA is in the way, disconnect the left CMA release and swing the CMA open. See Release the CMA.
- Reconnect the CMA.
Swing the CMA closed and latch it to the left rack rail. Refer to Attach the CMA to the Server in SPARC T7-1 Server Installation Guide.