You can perform this cold-service procedure. The server must be completely powered down before performing this procedure. See Component Service Categories for more information about this category of service procedures.
See Remove the SPM.
Ensure that the notched tab at the other end of the SPM is held in place.
See Attach Power Cords.
If the replacement SPM detects that the SPM firmware is not compatible with the existing host firmware, further action will be suspended and the following message will be displayed:
Unrecognized Chassis: This module is installed in an unknown or unsupported chassis. You must upgrade the firmware to a newer version that supports this chassis.
Refer to Configuring SP and Host Network Addresses in SPARC T8 Series Servers Administration Guide, or the Oracle ILOM documentation for network configuration instructions.
Follow the firmware download instructions in Updating the System Firmware in SPARC T8 Series Servers Administration Guide, or the Oracle ILOM documentation.
Refer to the Oracle ILOM documentation for instructions.
See Power On the Server (Oracle ILOM) or Power On the Server (System Power Button).
For information about initializing TPM using the Oracle ILOM interface to enable failover, see Securing Systems and Attached Devices in Oracle Solaris 11.3.
For information about migrating or restoring TPM data and keys, see Securing Systems and Attached Devices in Oracle Solaris 11.3.
See Verify the SPM.
-> show /SP/clock /SP/clock Properties: datetime = Tue Sep 07 08:09:59 2013 timezone = GMT (GMT) uptime = 0 days, 00:01:18 usentpserver = disabled ->
-> set /SP/clock datetime=MMDDhhmmYYYY
-> set /SP/clock timezone=3-to-4-characters
where the timezone value equals a three- or four-character timezone abbreviation, such as EST.
Oracle ILOM documentation