SPARC T8-1 Server Service Manual

Remove a PCIe Card or Filler

---

Caution  - This procedure requires that you handle components that are sensitive to ESD. This sensitivity can cause the component to fail. To avoid damage, ensure that you follow antistatic practices as described in ESD Measures.

---

This is a cold-service procedure that can be performed by a customer. Power down the server completely before performing this procedure. See Component Service Categories for more information about cold-service procedures.

1. Locate the PCIe card or filler that you want to remove.

   See Rear Panel Components for information about PCIe slots and their locations.

   If you are removing a PCIe filler, go to Step 5.

2. Note the slot location for each PCIe card you plan to remove.
3. Unplug all data cables from the PCIe card.

   Note the location of all cables for reinstallation later.

4. Remove any transceivers from the PCIe card before removing the card.
5. Remove the PCIe card by completing the following tasks.
   
   1. Rotate the PCIe card locking mechanism (panel 1).
   2. Carefully lift the PCIe card or filler from the card slot (panel 2).
6. Replace with another PCIe card or filler before the server is connected to power again.

   See Install a PCIe Card or Filler.

Related Information

• Install a PCIe Card or Filler