StorageTek Dual 8Gb FC Dual GbE HBA, ExpressModule, Emulex Installation Guide For HBA Models SG-XPCIEFCGBE-E8-Z, SG-PCIEFCGBE-E8-Z, SG-XPCIEFCGBE-E8-N, SG-PCIEFCGBE-E8-N and 7105393

Configuring the HBA for Hot-Plug Operation

To Configure the HBA for Hot-Plug Operation

1. Locate the green Power OK LED indicator near the bottom of the HBA front panel.

   Power OK LED indicator status is shown in the following table.

   Power OK LED State Meaning Removal Status Off No power to the HBA Removal is permitted, or the HBA must be configured Blinking Hot-plug in process Removal of the HBA is not permitted Solid green HBA is properly configured Removal is not permitted

2. If the green Power OK indicator is not illuminated, briefly press the Attention button near the bottom of the HBA front panel.

   The green Power OK LED will blink for approximately five seconds and then remain on, indicating that the HBA is properly configured.

3. To cancel the operation, press the Attention button again before the Power OK LED stops blinking.