Oracle ILOM Tasks
The following table lists many of the tasks you can perform using the Oracle ILOM
web or command-line interface.
|
|
|
System Information
|
/System
|
Review information about the server, including the serial
number and BIOS version.
View the overall health of the server and see a total problem
count, or view subcomponent health and inventory details.
|
Remote Control
|
/HOST/console
|
Configure and launch a remote console session.
Redirect storage devices.
|
Host Management
|
/HOST/diag
|
Run diagnostics on the server.
|
/HOST boot_device
|
Set the next boot device or control the server power
state.
|
System Management
|
/System/BIOS
|
View BIOS settings.
|
/System/BIOS/Config
|
Back up or restore a BIOS configuration.
|
/SP/policy
|
Configure system policies such as the Enhanced PCIe Cooling
Mode policy.
|
Power Management
|
/SP/powermgmt
|
View actual system power consumption.
View system power requirements for capacity planning.
View historical power usage data.
|
ILOM Administration
|
/SP system_identifier
|
Configure system identification information.
|
/SP/logs
|
View system event and audit logs.
|
/SP/clients
|
Configure remote management access to the server.
|
/SP/users
|
Configure Oracle ILOM user accounts.
|
/SP/network
/SP/network/ipv6
|
Configure service processor connectivity settings.
|
/SP/config
|
Back up or restore a service processor configuration.
|
/SP reset_to_defaults=factory
|
Reset the service processor to default settings.
|
/SP/alertmgmt
|
Configure alert notifications for system events and
faults.
|
/SP/clock
|
Set the service processor clock.
|
/SP/diag/snapshot
|
Take a snapshot of the service processor for troubleshooting
purposes.
|
|