Reset BIOS to Default Values (BIOS)
Setting defaults ensures that the server is operating with a configuration
that is known to be good.
Note -
If the server is newly installed and this is the first time an operating
system is being installed, then BIOS is probably already configured to its
default settings.
Any changes you make in the BIOS Setup Utility using the F2 key are permanent
until the next time you change them.
-
Ensure that your server is equipped with a properly installed hard disk
drive (HDD) or solid state drive (SSD). For instructions, refer to the
server Service Manual.
-
Access the BIOS Setup Utility.
For instructions, see Using UEFI and the BIOS Setup Utility.
-
To automatically load the optimal default settings, press the F9
key.
A message appears prompting you to continue this operation by selecting
OK or to cancel this operation by selecting
CANCEL.
-
In the message, highlight OK, and press Enter.
-
To save your changes and exit the BIOS Setup Utility, press the F10 key.
Alternatively, you can select Save and Exit from the
Exit menu.