Note - Do not remove the protective plastic covers from the connectors on the cable until you are ready to plug a cable connector into a socket.
Note - An adjustable torque screwdriver is included with the replacement cable assembly.
Do not discard the plastic cover. You will return the cover to Oracle.
Note - The cable connectors in the plastic block are keyed with flat tops. Align the tops of the cables to make it easier to insert the block in the connector on the midplane.
If the block does not insert easily, twist the individual cable ends so that the flat portions of the cable ends are all aligned and facing up.
Use the torque screwdriver that is included with the replacement cable assembly. Set the torque screwdriver to 10 in-lb.
Caution - Tighten the screws alternately, several turns at a time. If the plastic block is not kept parallel to the midplane, stress from the screws can break the block.
Tighten the screws to 15 in-lb.
See Install Trim Panels .
See Install the Door .
Place plastic cover(s) on the connectors of the component. Also return any extra covers that were included with the replacement component.