Remove the Server Module From the Modular System

1. Review the safety and handling precautions.

   See Safety Information.

   ---

   Caution  -  When the modular system is operating, you must fill every slot with a filler panel or a server module within 60 seconds.

   ---

2. Prepare the server module for removal.

   See Preparing the Server Module for Removal.

3. If a cable is connected to the front of the server module, disconnect it.

   Press the buttons on either side of the UCP to release the connector.

4. Open both ejector arms (panel 1).

   Squeeze both latches on each of the two ejector arms.

   
   
5. Pull the server module out (panel 2 and panel 3).
6. Close the ejector arms.
7. Remove the server module from the modular system (panel 3).

   Lift the server module with two hands.

8. Place the server module on an antistatic mat or surface.
9. Insert a filler panel into the empty chassis slot.

   ---

   Caution  -  When the modular system is operating, you must fill every slot with a filler panel or a server module within 60 seconds.

   ---

10. Access internal server module components.

    See Accessing Internal Components.

Related Information

• Remove the Cover

• Install the Server Module Into the Modular System