Before You Begin
The Reset and Host control (r) role is required to modify the SPARC diagnostic properties in Oracle ILOM on SPARC systems.
The Steps in this procedure apply to newer SPARC servers such as T7, M7, and later SPARC series servers.
Oracle ILOM firmware version 3.2.5.5 or later.
To enable SPARC diagnostics tests to run, do the following:
In the Oracle ILOM web interface, click System Management > Diagnostics.
The Diagnostics page appears.
In the CLI, type: cd /SP/diag
In the Diagnostics page, configure the following properties and click Save.
Default Level [Off (default), Min, or Max] — Specify the appropriate diagnostic behavior in the event of a routine server power cycle (power off/on) or a server reset.
HW Change [Off, Min, or Max (default)] — Specify the appropriate diagnostic behavior in the event of a server power-cord-cycle, server top cover removal, or FRU (field-replaceable unit) replacement.
where: [Off, Min, and Max]
Off — Prevent POST from running
Min — Run a basic suite of diagnostic tests
Max — Run a basic suite of diagnostic tests, plus extensive processor and memory tests.
In the CLI, issue the set command to configure the applicable host diagnostic properties:
set default_level=[off, min, max] hw_change=[off, min, max]
For further property details, type: help /sp/diag